P

Prusa Slicer

A cantilever to guide the filament over the X-axis.

A wall mount for an Einhell Power X-Change 18V cordless hoover TE-SV 18 Li-Solo. The original wall mount was too big for me, so I designed a smaller wall mount.

As it is getting warmer and warmer and the flower boxes on my balcony with the wildflowers - as well as my ‘insect hotel’ - are well visited by insects, I decided to create a small octagonal insect watering trough.

Der Original Abstandshalter war für meinen Sattelstützträger nicht optimal, daher habe ich eine besser geeigneten für meine Ortlieb Packtaschen entworfen.

A cup with a lid for bagged pasta snacks, other food and drinks or as an urn for the ashes of a bereaved person.

A bracket for the SIGMA Cuberider II rear light for mounting on the ROSE - Seat Post Carrier SPR III.

Case Replacement for the ALDI HOME CREATION Soft Touch Soap Dispenser. The housing is 20.0 mm lower than the original housing, the outer diameter is the same. The original housing had magnets in the base, which have now been removed.

A case for a Raspberry Pi 4/5 with camera bracket for a Raspberry Pi HQ camera V1.0 for side mounting on an Anycubic Kobra 3D printer. A housing cover with camera cable outlet only and a housing cover with camera cable outlet and additional opening for mounting a 40x40x10mm fan are optionally available.

Foldable notebook stand for notebooks up to 17 inches.

Ein Halter für eine B.K. Licht GmbH Unterbau LED Leiste an meinem Anycubic Kobra 2 Plus.